LevelOne GTL-2690 - Manual (Page 432)

Event Logging Commands
23-29
23
logging trap
This command enables the logging of system messages to a remote server, or
limits the syslog messages saved to a remote server based on severity. Use this
command without a specified level to enable remote logging. Use the no form to
disable remote logging.
Syntax
logging trap [level]
no logging trap
level - One of the syslog severity levels listed in the table on page 23-27.
Messages sent include the selected level up through level 0.
Default Setting
• Disabled
• Level 7 - 0
Command Mode
Global Configuration
Command Usage
• Using this command with a specified level enables remote logging and sets
the minimum severity level to be saved.
• Using this command without a specified level also enables remote logging, but
restores the minimum severity level to the default.
Example
clear log
This command clears messages from the log buffer.
Syntax
clear log [flash | ram]
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on
power reset).
Default Setting
Flash and RAM
Command Mode
Privileged Exec
Example
Console(config)#logging trap 4
Console(config)#
Console#clear log
Console#