LevelOne GTL-2690 - Manual (Page 548)

32-1
Chapter 32: LLDP Commands
Link Layer Discovery Protocol (LLDP) is used to discover basic information about
neighboring devices on the local broadcast domain. LLDP is a Layer 2 protocol that
uses periodic broadcasts to advertise information about the sending device.
Advertised information is represented in Type Length Value (TLV) format according
to the IEEE 802.1ab standard, and can include details such as device identification,
capabilities and configuration settings. LLDP also defines how to store and maintain
information gathered about the neighboring network nodes it discovers.
Table 32-1 LLDP Commands
Command Function Mode Page
lldp Enables LLDP globally on the switch GC 32-2
lldp holdtime-multiplier Configures the time-to-live (TTL) value sent in LLDP
advertisements
GC 32-3
lldp notification-interval Configures the allowed interval for sending SNMP
notifications about LLDP changes
GC 32-3
lldp refresh-interval Configures the periodic transmit interval for LLDP
advertisements
GC 32-4
lldp reinit-delay Configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down
GC 32-5
lldp tx-delay Configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB
variables
GC 32-5
lldp admin-status Enables LLDP transmit, receive, or transmit and receive
mode on the specified port
IC 32-6
lldp notification Enables the transmission of SNMP trap notifications about
LLDP changes
IC 32-6
lldp basic-tlv
management-ip-address
Configures an LLDP-enabled port to advertise the
management address for this device
IC 32-7
lldp basic-tlv
port-description
Configures an LLDP-enabled port to advertise its port
description
IC 32-8
lldp basic-tlv
system-capabilities
Configures an LLDP-enabled port to advertise its system
capabilities
IC 32-8
lldp basic-tlv
system-description
Configures an LLDP-enabled port to advertise the system
description
IC 32-9
lldp basic-tlv
system-name
Configures an LLDP-enabled port to advertise its system
name
IC 32-9
lldp dot1-tlv
proto-ident*
Configures an LLDP-enabled port to advertise the supported
protocols
IC 32-10
lldp dot1-tlv
proto-vid*
Configures an LLDP-enabled port to advertise port related
VLAN information
IC 32-10
lldp dot1-tlv
pvid*
Configures an LLDP-enabled port to advertise its default
VLAN ID
IC 32-11