LevelOne GTL-2690 User Manual

Page 82

Advertising
background image

Basic Management Tasks

4-6

4

Command Usage
• This section describes how to configure a single local interface for initial access to

the stack. To configure multiple IP interfaces on this stack, you must set up an IP
interface for each VLAN (page 19-4).

• To enable routing between the different interfaces on this stack, you must enable

IP routing (page 19-4).

• To enable routing between the interfaces defined on this stack and external

network interfaces, you must configure static routes (page 19-21) or use dynamic
routing; i.e., either RIP or OSPF (page 20-2 and page 20-14, respectively).

• The precedence for configuring IP interfaces is the IP / General / Routing Interface

menu (page 19-5), static routes (page 19-21), and then dynamic routing.

Command Attributes
VLAN – ID of the configured VLAN (1-4093). By default, all ports on the stack are

members of VLAN 1. However, the management station can be attached to a port
belonging to any VLAN, as long as that VLAN has been assigned an IP address.

IP Address Mode – Specifies whether IP functionality is enabled via manual

configuration (Static), Dynamic Host Configuration Protocol (DHCP), or Boot
Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will not function until a reply has
been received from the server. Requests will be broadcast periodically by the
switch for an IP address. (DHCP/BOOTP values can include the IP address,
subnet mask, and default gateway.)

IP Address – Address of the VLAN to which the management station is attached.

(Note that you can manage the stack through any configured IP interface.) Valid IP
addresses consist of four numbers, 0 to 255, separated by periods.
(Default: 0.0.0.0)

Subnet Mask – This mask identifies the host address bits used for routing to

specific subnets. (Default: 255.0.0.0)

Gateway IP Address – IP address of the gateway router between the stack and

management stations that exist on other network segments. (Default: 0.0.0.0)

MAC Address – The physical layer address for this switch.

Advertising