Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 13)

SierraFC M164 Protocol Analyzer User Manual 13
Teledyne LeCroy
On the back, the Analyzer has:
 Power In
 STX SYNC Expansion Card In/Out data ports (optional)
Figure 1.3: Back Panel
LEDs
LEDs support each port link, with the following functionality (refer to Figure 1.4 on
page 13 ):
Trigger Illuminates when a trigger occurs.
Blue
Error Illuminates when an error occurs.
Red
Link Illuminates when a link is established.
Yellow
Frame After the link is established, indicates traffic on the bus.
Green
There are five LEDs on the left of the analyzer for ports P1 and P2, and five LEDs on the
right of the analyzer for ports P3 and P4. These 10 LEDs indicate the speed of 1Gbps,
2Gbps, 4Gbps, 8Gbps and 16Gbps. Speed LEDs are off when there is no link (see the
following figure and
Figure 1.2 on page 12 ).
Figure 1.4: LEDs on the Left Front Panel