Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 40)

Teledyne LeCroy Easy Mode (Pre‐Defined Setups)
40 SierraFC M164 Protocol Analyzer User Manual
You can limit the range of the saved file. You can save:
 All Traces
 A range between selected cursors
 A range between selected levels of decoding. The levels allowed are dependent
on the traffic in the trace. A trace with only Switch traffic might have the follow‐
ing levels available: ELS Cmd, Frame, GS Cmd, Sequence and SW Cmd, whereas a
read‐write trace might have Frame, SCSI Cmd and Sequence available.
 A range between selected timestamps. Specify the time format from the drop‐
down list.
Save Filtered Sample checkbox saves a trace file without filtered data.
CrossSync Control Panel
The CrossSync Control Panel allows you to select analyzers for synchronization and
manage the recording process.
Launching the CrossSync Control Panel
To launch CrossSync from the FC Protocol Suite software application, select the ‘Launch
CrossSync Control Panel ‘entry in the ‘Project Setup’ menu (see the screen below). Or,
you can launch CrossSync from the ‘Start’ menu.
Figure 2.7: Launching CrossSync from the SierraFC M164 Protocol Suite Application
Please refer to the CrossSync Control Panel User Manual for more information.