Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 158)

Teledyne LeCroy Easy Mode (Pre‐Defined Setups)
158 SierraFC M164 Protocol Analyzer User Manual
Timeout
Selecting Timeout for the pattern opens the Add Timeout Pattern dialog (see
Figure 2.121 on page 158 ).
Figure 2.121: Add Timeout Pattern Dialog
Select a pattern for Start Events or End Events, enter a Timeout value, select units, and
then select Trigger Mode:
 Trigger If the ‘End Event(s)’ occur(s) before the timer expires
 Trigger if the timer expires before ‘End Event(s)’ occur(s)
Note: You cannot select a Timeout pattern if you select any other pattern as the trigger condition.