Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 149)

SierraFC M164 Protocol Analyzer User Manual 149
Easy Mode (Pre‐Defined Setups) Teledyne LeCroy
 FC‐AE 1553
 FC‐ASM
 FC‐VI
 FC‐AV Container
 ARINC 818
 Generic FC Feat
 RNID Gen. Top. Dis. Page
Protocol Errors
Double‐click Protocol Errors to open the Add Protocol Error Pattern selection dialog.
Figure 2.114: Protocol Error Pattern Dialog
Check protocol error(s) and then click OK.
Trigger Setup
The Trigger tab in the analysis project dialog allows you to specify when the analyzer
completes a data capture. Three trigger modes are available: The default Snapshot,
Manual Trigger, and Pattern/Event Trigger.
When data capture starts with Don’t care (Snapshot) selected, the analyzer triggers on
the first data pattern on the bus.
Starting a data capture with Pattern selected triggers when specific pattern(s) are
detected in the captured data stream. The following three ways can trigger the analyzer
with Pattern selected:
 Trigger on any pattern (Any Trigger Mode)