Teledyne LeCroy SierraFC M164 User Manual - Manual (Page 17)

SierraFC M164 Protocol Analyzer User Manual 17
Hardware Setup Teledyne LeCroy
Hardware Setup
The hardware setup is described below.
Connecting in General
Note: You must install the software before connecting the analyzer to the host machine for the first
time.
To set up the analyzer:
1. Connect the analyzer to a 100V–240V, 50Hz–60Hz, power outlet and turn on the
Power switch.
At power on, the analyzer will go through initialization as shown on the LCD display.
2. Connect the USB cable between the SierraFC M164 USB port and a USB port on the
host machine. The host machine operating system detects the analyzer and driver
files.
(See
“Connecting via Ethernet” on page 26 for Ethernet connectivity.)
3. Connect the analyzer as shown in the following figure. The figure shows one
possible connection from an Initiator to a hard drive.
Figure 1.7: Analyzer Connections