ZOLL AutoPulse Rev A - Manual (Page 29)

P/N. 12457-001 Rev. 2 Page 5-7
Power System User Guide
Figure 5-6 Three Battery rotation
Three Battery Rotation—to be done after every use and/or once per shift (see Figure 5-6 above).
• Remove the Battery from the AutoPulse and place into the Charger.
• Check the spare Battery for green LED’s, and then place it in the AutoPulse. (If the spare Battery is
not fully charged, place it in the Charger and use one that is fully charged.)
• Remove a fully charged Battery from the Charger and use it as the spare Battery.
• Power on AutoPulse and ensure no faults are displayed.
3
Place the Battery that
was in the AutoPulse
into the Charger.
2
Install the previous
spare Battery into
the AutoPulse.
1
Remove fully charged
Battery from the
Charger and store it
with the AutoPulse
as the spare.
Check the Battery
status
LED s before
placing a Battery
in service.
Recommended daily 3 Battery maintenance routine