ZOLL AutoPulse Rev C - Manual (Page 15)

P/N. 10762-001 Rev. 8 Page 2-1
Battery Charger User Guide
2 Setting Up the AutoPulse Battery Charger
The AutoPulse Battery Charger must be installed near the wall outlet to which it is connected and that
outlet must be easily accessible at all times. Unplug the power cord from the wall outlet to remove power
from the Battery Charger.
Caution: Do not block the Battery Charger’s ventilation slots.
Caution: Do not operate the Battery Charger in a confined space.
Caution: Keep the Battery Charger away from moisture.
Caution: Use the Battery Charger only with ZOLL Circulation AutoPulse Battery Charger power cord.
Caution: Grounding reliability can only be achieved when the Battery Charger is connected to an
equivalent receptacle marked “hospital only” or “hospital grade.”
To prepare the Battery Charger for use:
1. Plug the alternating current (AC) power cord into the power receptacle on the back of the Battery
Charger.
2. Plug the AC power cord into an appropriate wall outlet receptacle.
When the POWER indicator (green LED) on the Battery Charger’s Control Panel illuminates, the
Battery Charger is ready for use.
If, after properly plugging in the Battery Charger, the green Power light on the Control Panel does not
illuminate, read Section 5.3.2, “Replacing a Battery Charger Fuse”.
Note: When powering up the Battery Charger, all indicators on the Control Panel will illuminate
briefly to provide a visual check that the indicator lights are functioning. If an indicator fails to
illuminate, contact ZOLL Circulation.