4 operating the battery charger, 1 operating sequence, 4 operating the battery charger -1 – ZOLL AutoPulse Rev C User Manual
Page 19: 1 operating sequence -1, 4operating the battery charger
P/N. 10762-001 Rev. 8
Page 4-1
Battery Charger User Guide
4
Operating the Battery Charger
4.1
Operating Sequence
You should place the AutoPulse Battery into an available charging bay:
•
Following each use.
•
When the Battery’s amber status light-emitting diode (LED) illuminates or flashes.
•
To maintain a charge on any spare Battery.
Caution: Remove the protective plastic cap from the Battery before attempting to charge the Battery.
One or two Batteries placed in a charging bay are automatically charged (yellow CHARGING LED will
illuminate) in less than 4
1
/
4
hours.
To charge a Battery, follow these steps:
Note:
For optimal charging, make sure that the Battery and Battery Charger are at room
temperature (68º to 77ºF [20º to 25ºC]).
Note:
Do not slam the Battery into the Battery Charger because doing so may cause damage to
the Battery’s connector.
Note:
The Battery is mechanically keyed so that it can only be inserted in one orientation. Do
not force the Battery into the charging bay. If resistance is met, check for appropriate
orientation, and check to ensure that there are no obstructions to Battery insertion.
Warning: Always charge a new Battery. Failure to charge a Battery may cause reduced Battery
performance.