ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 102)

Accesories - HMIA
8
Figure 5 The Hirose Connector – Rear of the Display Head
3. Verify that the connector type on the end of the Umbilical Cable is
identical to the connector on the HMIA. 601033–001 for the 8-pin circular
connector and 601033–002 for the 6-pin circular connector. If the
connectors are incompatible then contact ZOLL to arrange for a
replacement.
4. Remove the paper protecting the Velcro® strips found on the mounting
surface of the HMIA.
5. Hang the HMIA on the stainless steel bracket located on the back of the
Display Housing. The connectors on the HMIA should be facing
downward.
6. Press on the lower half the HMIA until the snaps engage.
7. Connect the Umbilical Cable to the mating connector on the HMIA
labelled SYSTEM .
8. Connect the cable with the circular connector to the mating connector on
the rear of the Display Housing.
600479-001 Rev 2 102/147