IEI Integration PCISA-945GSE v1.10 - Manual (Page 66)

PCISA-945GSE CPU Card
Page 48
contact the PCISA-945GSE vendor reseller/vendor where the PCISA-945GSE was
purchased or contact an IEI sales representative.
4.4 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.
Figure 4-1: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket. Place the board on an anti-static mat.
Step 2: Align the SO-DIMM with the socket. Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM. Push the memory in at a 20º angle. (See Figure 4-1)
Step 4: Seat the SO-DIMM. Gently push downwards and the arms clip into place. (See
Figure 4-1) Step 4:
4.5 CF Card Installation
NOTE:
The PCISA-945GSE can support both CF Type I cards and CF Type II
cards. For the complete specifications of the supported CF cards
please refer to Chapter 2.
To install the a CF card (Type 1 or Type 2) onto the PCISA-945GSE, please follow the
steps below: