IEI Integration PCISA-945GSE v1.10 - Manual (Page 71)

PCISA-945GSE CPU Card
Page 53
4.7.2 Clear CMOS Jumper
Jumper Label: J_CMOS1
Jumper Type: 3-pin header
Jumper Settings: See
7
Table 4-3
Jumper Location: See Figure 4-4
If the PCISA-945GSE fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ Enter the correct CMOS setting
ƒ Load Optimal Defaults
ƒ Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
7
Table 4-3.
AT Power Select Description
1-2 Keep CMOS Setup
2-3 Clear CMOS Setup
Table 4-3: Clear CMOS Jumper Settings
4.7.3 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See Table 4-4
Jumper Location: See Figure 4-4