Figure 4-5: 5.1 channel audio kit – IEI Integration PCISA-945GSE v1.10 User Manual
Page 76
PCISA-945GSE CPU Card
Page 58
Step 5:
Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 6:
Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
cable connector. Pin 1 on the audio kit cable connector is indicated with a white
dot. See Figure 4-5.
Figure 4-5: 5.1 Channel Audio Kit
Step 7:
Mount the audio kit onto the chassis. Once the audio kit is connected to the
PCISA-945GSE, secure the audio kit bracket to the system chassis.
Step 8:
Connect the audio devices. Connect one speaker to the line-in audio jack, one
speaker to the line-out audio jack and a microphone to the mic-in audio jack.
Step 9:
Install the driver. If the 5.1 channel audio kit is used, the ALC655 Realtek
codec driver must be installed. Refer to Chapter 7 for driver installation
instructions.
Step 0: