IEI Integration PCISA-945GSE v1.10 - Manual (Page 67)

PCISA-945GSE CPU Card
Page 49
Step 5: Locate the CF card socket. Place the PCISA-945GSE on an anti-static pad
with the solder side facing up. Locate the CF card.
Step 6: Align the CF card. Make sure the CF card is properly aligned with the CF
socket.
Step 7: Insert the CF card. Gently insert the CF card into the socket making sure the
socket pins are properly inserted into the socket. See Figure 4-2. Step 0:
Figure 4-2: CF Card Installation
4.6 ATX Power Control Connector
The ATX power control connector is required when using an ATX power source. To setup
the PCISA-945GSE for ATX power, follow the steps below.
Step 1: Set the ATX jumpers (there are two) as shown in AT/ATX Power Selection in
Section 4.7.1.