IEI Integration PCISA-945GSE v1.10 - Manual (Page 70)

PCISA-945GSE CPU Card
Page 52
Figure 4-4: Jumper Location
4.7.1 AT/ATX Power Selection
Jumper Label: ATXCTL1 and J_AUTOPWR1
Jumper Type: 3-pin wafer and 2-pin header
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-4
The AT/ATX power selection jumpers set the system power mode as AT or ATX. Jumper
settings are shown below.
Jumper ATXCTL1 J_AUTOPWR1
AT 1-2 Short
ATX Connect to PS_ON#
and 5 VSB
Open
Table 4-2: AT/ATX Power Selection Jumper Settings