IEI Integration PCISA-945GSE v1.10 - Manual (Page 80)

PCISA-945GSE CPU Card
Page 62
Step 2: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 4-8. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-8: Dual RS-232 Cable Installation
Step 3: Secure the bracket. The dual RS-232 connector has two D-sub 9 male
connectors secured on a bracket. To secure the bracket to the chassis please
refer to the reference material that came with the chassis. Step 0:
4.9.5 Floppy Drive Cable Connection
The FDD flat cable connects to the PCISA-945GSE to one FDD device. To connect an
FDD to the PCISA-945GSE please follow the instructions below.
Step 1: Locate the FDD connector. The location of the FDD device connector is shown
in Chapter 3.