Watlow Series 935A - Manual (Page 11)

Watlow Series 935A User’s Manual 9
Software Organization
• The Series 935A has three primary menus in addition to a normal display.
• The software reverts to the normal display after 60 ± 5 sec.
Table 3 - Software Organization
• At the [`pid] or [Cnfg] prompt, press and hold the ß key, and the . or , key to select [`yes] . Release the keys to
move to the new menu.
Navigation Example
Learn the Software Map
,
,
,
Display
Actual Temperature, Set Point, or Time Remaining
Operations
, p. 10
Start / Stop:
•Autotune
Set:
•Alarm Ranges
•Countdown Timer
•Idle after Timer
Select
Set Point Type:
Go to:
PID Menu
Configuration Menu
PID
, p. 12
Set:
•Heat PID Functions
•Dead Band
•Cool PID Functions
•Calibration Offset
Configuration
, p. 16
Set:
•Inputs / Functions
•Output Types
•Display Default
•Alarms / Functions
•Timer Functions
•Failure Mode
•Lockout Functions
[`yes]
[`yes]
• To access the Operations Menu, press the
. and , keys simultaneously for three seconds.
• Move through each menu with the . or , key.
• Make changes by pressing and holding the ß key, and
then the . or , key to select a new choice or
value. Release the keys to complete the change.
• To exit any menu: Press and hold the
. and , keys for three seconds,
or
the display will revert to normal display
after 60± 5 seconds.
[Prnc] [Prno [dEnc [dEno
[`Ot2]
[disp]
[Alty]
,
.
.
.
, , , ,