Watlow Series D8 - Manual (Page 139)

Doc. 0600-3120-2000 Watlow Anafaze 121
6
Menu and Parameter Reference
The D8 has operator and setup parameters that let you change
the configuration of the controller. This section contains the
following information for each operator and setup parameter:
•
Description
• Values
• Default value
• Information for addressing controller parameters via
DeviceNet.
For information about how to access the operator and setup
parameters, see the Operation and Setup chapter.
Operator Parameters
Use the operator parameters to change the set point, control
mode or output power level.
Figure 6.1 Operator Parameter Navigation
Cancel a change without saving.
Escape to the loop display.
Edit parameter values.
Save a value and go to the previous parameter.
Save a value and go to the next or previous loop.
Access the operator parameters (from the loop display).
Save a value and go to the next parameter.
.
,
><
p
x