Watlow Series D8 - Manual (Page 86)

Chapter 3: Communicating by DeviceNet Series D8 User’s Guide
68 Watlow Anafaze Doc. 0600-3120-2000
Table 3.20 Input Instance Attributes
(Instances 1 to 4 or 8)
NOTE! All successful explicit message responses
from a Set service will contain no data. The
response will be a two-byte message con-
taining the requester’s node address and
service code (with R/R bit set).
Output Object
The Output Object provides read/write access to all output pa-
rameters. Instance 0 of this object contains the class attributes
listed in Table 3.22. The four-loop controller has four addi-
tional instances, and the eight-loop controller has eight addi-
tional instances, each containing the attributes listed in
Table 3.23. Instance 1 corresponds to loop 1, instance 2 cor-
responds to loop 2, and so on.
Table 3.21 Output Class and Services
Attribute Access Name Type Description
100 (64 hex) Get/Set Set Point INT See page 122.
101 (65 hex) Get Process Variable INT See page 123.
102 (66 hex) Get/Set Input Type SHORT_STRING See page 131.
103 (67 hex) Get/Set Loop Name SHORT_STRING See page 132.
104 (68 hex) Get/Set Input Units Array of 3 USINT See page 132.
105 (69 hex) Get/Set Calibration Offset INT See page 132.
106 (6A hex) Get/Set
Reverse Thermo-
couple Detection
BOOL See page 133.
107 (6B hex) Get/Set Display Format USINT See page 133.
108 (6C hex) Get/Set Input Range High INT See page 134.
109 (6D hex) Get/Set Input Range Low INT See page 135.
110 (6E hex) Get/Set Input High Signal INT See page 134.
111 (6F hex) Get/Set Input Low Signal INT See page 135.
112 (70 hex) Get/Set Input Filter USINT See page 135.
Class Code 65 hex
Class Services 0E hex Get Attribute Single
Instance Services
0E hex Get Attribute Single
10 hex Set Attribute Single