Yokogawa Standalone MW100 - Manual (Page 101)

-
101/131 -
IM MW100-S16E-1
Ed01
2.5.13. DNP server destination setting (VW)
This command is used to configure destination of DNP server. For implementing
DNP communication functions, this command is added.
- Setting
VW p1, p2 (in case p2 is 65520) 30 31
VW p1, p2, p3, p4 (in case p2 is not 65520)
p1 : Destination number (01 to 10)
p2 : DNP address of DNP client (0 to 65520)
p3 : IP address of DNP client (0.0.0.0 to 255.255.255.255)
p4 : Service port of DNP client (1 to 65535)
- Query
VW [p1] ?
30 Unless DNP option is specified, command can't be used.
31 When 65520 is set to p2, entry is disabled.