2 geo, 1 speaker wiring, 1 geo d10 connectors – Nexo GEO D User Manual

Page 10

Advertising
background image

Page 10/97

GEO

D

G

ENERAL

S

ET

-

UP

I

NSTRUCTIONS

2 GEO

D

G

ENERAL

S

ET

-

UP

I

NSTRUCTIONS

2.1 Speaker

Wiring

2.1.1 GEO

D10

connectors

GEO D’s are connected to power amplifiers via one AP6 Male Connector (GEOT-612M) on a link cable
that is stowed in the rear vent port. One EP6 Female Chassis (GEOT-613F) on the back connector
panel is used as output to feed the next GEO D.

A wiring diagram is printed on the connection panel located on the back of each cabinet. The EP6 / AP6
connectors are linked in parallel within the enclosures (see the Connections Diagrams section of this
manual).

EP6/AP6 Pin #

1 / 2

3 / 4

5 / 6-

GEO D10
Passive Mode

Rear 8” LF - 16 Ω

1 Negative – 2 Positive

Front 12” LF/MF & 1.4”HF - 16 Ω

3 Negative – 4 Positive

Not Connected

GEO D10
Active Mode

Rear 8” LF - 16 Ω

1 Negative – 2 Positive

Front 12” LF/MF - 16 Ω

3 Negative – 4 Positive

1.4” HF – 16 Ω

5 Negative – 6 Positive

IMPORTANT

NEVER USE a male AP6 connector to feed the signal:

High voltages and currents are delivered from the amplifiers to the GEO D system.

EXPOSURE

T

O

HIGH SOUND

PRESSURE LEVELS MA

Y CA

USE

A

PERMANENT HEARING LOSS.

REFER

T

O

USER MANU

AL.

ININ

OUTO

U

T

GEO D10 REAR CONNECTOR PANEL

2.1.2 Configuring GeoD10 for Passive or Active Mode

WARNING

GEO D SERIAL #0100 to #1610 PASSIVE FILTERS DO NOT OPERATE PROPERLY IN ACTIVE
MODE:
IF YOUR GEO D’s ARE WITHIN THESE NUMBERS, PLEASE CONTACT NEXO OR YOUR LOCAL
DISTRIBUTOR SO THAT INSTRUCTIONS AND COMPONENTS ARE SENT TO YOU FOR FILTER
MODIFICATION

Advertising