Nexo GEO D - Manual (Page 41)

GEO D RIGGING PROCEDURE Page 41/97
5.5 GEO D Cluster Flying Setup (2 motors)
Flying a GEO D10 cluster from 2 motors requires the following accessories:
• 2 x Motors properly rated
• 1 x GEO D Main Bumper (GEOD-BUMPER)
• 1 x GEO D Short Extension Bar (GEOD-EXBAR1)
• 1 x GEOD Front Extension Bar if strong positive tilt is required (GEOD-EXBAR4)
• 1 x GEO D Bottom Bumper (GEOD-BTBUMPER)
• 1 x GEO D Chain Lever Hoist (LEVA0750 or LEVA1500)
• 1 x Chain Bag (CHBAG)
• 6 x GEOD push-pins per flown GEO D10 (BLGEOD)
• or 1 x GEOD shoulder bolts and nuts kit for fixed installations per flown GEO D (GEOD-BNFIX)
IMPORTANT
Each of front, rear motor and chain lever hoists must be rated to support the entire
cluster weight.
Please check configurations in Geosoft2 for proper motor and chain lever hoists rating
5.5.1 Bumper Assembly
• Strong bumper positive tilt only; connect the Front Extension Bar Bumper through the Link
Points the with the two axes using corresponding holes (see drawing below), and ensure that
these axes are properly locked with supplied “R” clips;
Link Points
LINKING GEOD BUMPER AND EXTENSION BAR EXBAR4
• Connect the Short Extension Bar EX1 to the Main Bumper through the Link Points the with the
two axes using corresponding holes (see drawing below), and ensure that these axes are
properly locked with supplied “R” clips;
LINKING GEOD BUMPER AND EXTENSION BAR EX1
• Link the motor hoists to the Bumper – Extension Bar assembly to Front and Rear Rigging Points
with the two axes using corresponding holes (see drawing below), and ensure that these axes
are properly locked with supplied “R” clips;
• Attach the chain hook of the LEVA500 or LEVA1500 Chain Lever Hoist to the Compression Point
(see drawing below).