Nexo GEO D - Manual (Page 52)

Page 52/97 GEO D RIGGING PROCEDURE
• Lift bumper and top GEO SUB assembly, and position the next GEO SUB below the assembly,
with NEXO logo on the same side than the upper cabinet.
• Lower bumper and top GEO SUB assembly carefully until the first and second GEO SUB side
rigging plates locate. Use front grid, rear vent ports or handle to guide the assembly. The rigging
plates have been designed to locate against each other and so align the holes correctly.
• Connect the upper GEO SUB link bar to the lower GEO SUB rigging plate (or lower link bar to
upper rigging plate for “Right” configuration) by inserting one 10mm x 20 mm push-pin in the
“SAFETY PIN MUST BE FITTED” hole on each side (see figure below).
IMPORTANT
The push-pins for “SAFETY PIN MUST BE FITTED” holes must always be inserted first and
stay in position permanently. NEVER REMOVE THEM ONCE CABINETS ARE SUSPENDED.
« SAFETY PIN MUST BE FITTED »
HOLE