Nexo GEO D - Manual (Page 43)

GEO D RIGGING PROCEDURE Page 43/97
• Position the bumper on the first GEO D10 by lifting or lowering bumper assembly with motor
hoists;
• Link the GEO D10 to the bumper assembly using the four 10mm x 20mm push-pins; front
bumper connects at GEO D10 front articulation point, rear bumper connects at “LIFT” GEO D10
rigging plates holes;
• Check that all push-pins are in their locked position.
• Ensure that no objects have been placed accidentally on the top of the bumper as they may fall
when the system is lifted.
FIRST GEO D10 TO BUMPER ASSEMBLY
“RIGHT“ CONFIGURATION “LEFT“ CONFIGURATION
5.5.3 First to second GEO D 10
FIRST TO SECOND GEO D10