Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 233)

device(config-gvrp)#enable ethernet 1/24 ethernet 6/24 ethernet 8/17
device(config-gvrp)#block-learning ethernet 1/24 ethernet 6/24 ethernet 8/17
These VLAN commands configure VLANs 20, 30, 40, and 50. The GVRP commands enable the
protocol on the ports that are connected to the edge devices, and disable VLAN learning on those ports.
All the VLANs are advertised by GVRP.
Enter the following commands on edge devices A, B, and C.
device> enable
device#configure terminal
device(config)#gvrp-enable
device(config-gvrp)#enable all
device(config-gvrp)#block-applicant all
Fixed core and fixed edge
The VLANs are statically configured on the core and edge devices. On each edge device, VLAN
advertising is enabled but learning is disabled. GVRP is not configured on the core device. This
configuration enables the devices in the edge clouds to learn the VLANs configured on the edge
devices.
This configuration does not use any GVRP configuration on the core device.
The configuration on the edge device is the same as in Dynamic core and fixed edge on page 231.
Fixed core and fixed edge
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 233
53-1003086-04