Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 445)

mac-notification interval
Specifies the MAC-notification interval in seconds between each set of generated traps. The no form of
this command sets the interval to its default value.
Syntax mac-notification interval secs
no mac-notification interval
Command Default There is no interval set for MAC-notification.
Parameters secs
Specifies the MAC-notification interval in seconds between each set of traps that are
generated. The range is from 1 through 3600 seconds (1 hour). The default range is 3
seconds.
Modes Global configuration
Usage Guidelines Depending on the interval you specify, a trap will be sent aggregating the MAC events such as addition
or deletion.
Examples The following example configures an interval of 40 seconds.
device(config)# mac-notification interval 40
The following example sets the interval to its default value:
device(config)# no mac-notification interval 3
History
Release version Command history
08.0.10 This command was introduced.
mac-notification interval
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 445
53-1003086-04