Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 447)

show interface l2-tunnel
Displays VXLAN Layer 2 tunnel interface details.
Syntax show interface l2-tunnel tunnel-id
Parameters tunnel-id
Specifies the tunnel ID for the Layer 2 tunnel interface.
Modes Privileged EXEC mode
Global configuration mode
Command Output The show interface l2-tunnel command displays the following information:
Output field Description
L2-Tunnel Identifies the VXLAN tunnel and displays the source and destination
addresses. The status of the tunnel is also displayed.
VXLAN mappings Displays the mapping information of the port, VLAN, and VNI.
Examples The following example shows the output of the show interface l2-tunnel command.
device# show interface l2-tunnel 1
L2-Tunnel 1 is up, line protocol is up
L2-Tunnel source is 10.0.0.1
L2-Tunnel destination is 20.0.0.1
L2-Tunnel mode vxlan eline
Port name is VXLAN_INST_100
MTU 1452 bytes, encapsulation UDP-VXLAN
VXLAN mappings:
port e 1/1/1 vlan 10 vni 1010
port e 1/1/1 vlan 20 vni 200
History
Release version Command history
08.0.10d This command was introduced.
show interface l2-tunnel
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 447
53-1003086-04