Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 439)

errdisable packet-inerror-detect
Enables the device to monitor configured ports for inError packets and defines the sampling time
interval in which the number of inError packets is counted. The no form of this command disables this
monitoring.
Syntax errdisable packet-inerror-detect sampling-interval
no errdisable packet-inerror-detect sampling-interval
Command Default There is no monitoring for inError packets on any port of the device.
Parameters sampling-interval
Specifies the sampling interval in seconds. It can take a value in the inclusive range of 2 to
60 seconds.
Modes Global configuration mode
Usage Guidelines If the number of inError packets exceeds the configured threshold for two consecutive sampling
windows, then the configured port is error-disabled.
Examples The following example shows the sampling interval set to three seconds.
Brocade(config)# errdisable packet-inerror-detect interval 3
History
Release version Command history
07.3.00g This command was introduced.
errdisable packet-inerror-detect
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 439
53-1003086-04