Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 42)

System parameters in show default values command (Continued) TABLE 5
Parameter Definition
ip-route Learned IP routes
ip-static-arp Static IP ARP entries
ip-static-route Static IP routes
ip-subnet-port IP subnets per port
l3-vlan Layer 3 VLANs
mac MAC entries
mac-filter-port MAC address filter entries per port
mac-filter-sys MAC address filter entries per system
multicast-route Multicast routes
pim-mcache PIM multicast cache entries
rmon-entries RMON control table entries
session-limit Session entries
spanning-tree Spanning tree instances
view SNMP views
virtual-interface Virtual routing interfaces
vlan VLANs
mld-max-group-addr MLD group limit
igmp-snoop-mcache IGMP snooping cache entries
mld-snoop-mcache MLD snooping cache entries
Modifying system parameter default values
Information for the configurable tables appears under the columns that are shown in bold type in the
above examples. To simplify configuration, the command parameter you enter to configure the table is
used for the table name. For example, to increase the capacity of the IP route table, enter the following
commands.
device(config)#system-max ip-route 120000
device(config)#write memory
device(config)#exit
device#reload
Syntax: system-max ip-route num
Modifying system parameter default values
42 FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04