Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 427)

Displaying PVLAN information
To display the PVLAN configuration with respect to the primary VLAN and its associated secondary
VLANs and to display the member ports, promiscous ports, and the switch-switch link ports of a PVLAN,
enter a command such as the following.
device# show pvlan
PVLAN: primary VLAN 100
Port 1/1/4 1/1/10 1/1/11
Community VLAN 102
Port 1/1/1 1/1/2 1/1/10 1/1/11
Promiscuous Port: 1/1/4
Inter switch link Port: 1/1/10 1/1/11
BpduGuard enabled Port: 1/1/1 1/1/2
Isolate VLAN 101
Port 1/1/3 1/1/10 1/1/11
Promiscuous Port: 1/1/4
Inter switch link Port: 1/1/10 1/1/11
BpduGuard enabled Port: 1/1/1 1/1/2
Syntax: show pvlan vid
The vid variable specifies the VLAN ID of the PVLAN. If the VLAN ID is not specified, the command
displays the default VLAN ID.
NOTE
The show pvlan command is not supported on software forwarding platforms.
Displaying PVLAN information
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 427
53-1003086-04