Ring initialization – Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide User Manual
Page 78
Advertising
NOTE
Any node on an MRP ring that has two shared interfaces cannot be elected as the master node.
on page 77, any of the nodes on Ring 1, even S1 or S2, can be a master node since none
of its interfaces are tunnel ports. However in Ring 2, neither S1 nor S2 can be a master node since
these nodes contain tunnel ports.
Ring initialization
on page 74 shows the port states in a fully initialized ring without any
shows the initial state of the ring, when MRP is first enabled on the ring
switches. All ring interfaces on the master node and member nodes begin in the Preforwarding state
(PF).
FIGURE 5 Metro ring - initial state
Ring initialization
78
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04
Advertising