GW Instek GDS-1000A-U Series Programming Manual - Manual (Page 82)

GDS-1000A-U Programming Manual
82
Example :trigger:type 0
:trigger:nrej 0 Selects the edge trigger
and turns off the noise
rejection
:TRIGger:PULSe:MODe
Set
Query
Description Selects the trigger mode in the pulse trigger.
Same as: Trigger key → F1(Pulse) → F3
Syntax < Long > < Short >
:trigger:pulse:mode <NR1>
:trigger:pulse:mode? :trig:puls:mod <NR1>
:trig:puls:mod?
Parameter <NR1> Mode <NR1> Mode
0 < 2 =
1 > 3 ≠
Note Before using this command, select the pulse
trigger. See the example below.
Example :trigger:type 2
:trigger:pulse:mode 0 Selects the pulse trigger
and < (smaller than) as
the trigger mode
:TRIGger:PULSe:TIMe
Set
Query
Description Selects the trigger time in the pulse trigger.
Same as: Trigger key → F1(Pulse) → F3 → Variable
knob
Syntax < Long > < Short >
:trigger:pulse:time <NR3>
:trigger:pulse:time? :trig:puls:tim <NR3>
:trig:puls:tim?
Parameter <NR3> Trigger time
20e -9 ~ 10 20ns ~ 10s
Note Before using this command, select the pulse
trigger. See the example below.