GW Instek GDS-3000 Series User Manual User Manual

Page 181

Advertising
background image

REMOTE CONTROL CONFIG

181

Background

The Ethernet interface is used for remote control
over a network.

Panel Operation

1. Press the Utility key.

Utility

2. Press I/O from the bottom menu.

3. Press Ethernet from the side menu.

4. Set DHCP/BOOTP to On or Off

from the side menu.

Note

IP addresses will automatically be assigned with
DHCP/BOOTP set to on. For Static IP Addresses,
DHCP/BOOTP should be set to off.

Advertising
See also other documents in the category GW Instek Equipment: