GW Instek GDS-3000 Series User Manual - Manual (Page 191)

MAINTENANCE
191
Probe Compensation
Panel Operation 1. Connect the probe between the Channel1 input
and the probe compensation output (2Vp-p,
1kHz square wave) on the front panel. Set the
probe attenuation to x10 (GDP probes are fixed
at x10).
VOLTS/DIV VOLTS/DIV VOLTS/DIV VOLTS/DIV
POSITION POSITION POSITION
TIME/DIV
POSITION
HORIZONTAL VARIABLE
W AC BW 50 W 75
VERTICAL
LEVEL
POSITION
TRIGGER
W AC BW 50 W 75 W AC BW 50 W 75 W AC BW 50 W 75
CH4 CH3 CH2 CH1 EXT TRIG POWER 2V
Window Split Select Zoom
CH1 CH2 CH3 CH4
R
B1
Measure Cursor
Display Help
Test
Save/Recall Utility
Menu
50 %
Force - Trig
Autoset
Single
Run/Stop
Setup
Auto-Range
Default Acquire
M
B2
MATH
REF
BUS
Off Menu
Print
Save
x1
x10
X 1 0
X 1
2. Press the CH1 key to activate CH1.
CH1
3. Set the Coupling to DC from the
bottom menu.
4. Set Impedance to 1MΩ from the
bottom menu.
5. Set the Probe attenuation to
Voltage, 10X.
Page 123
6. Press the Autoset key. The
compensation signal appears on
the display.
Autoset
7. Press the Display key, then
set the display type to
Vector.
Display