AT&T EP5632/EP5632-2 - Manual (Page 22)

18
Getting started
Spare battery (optional)
You can keep a charged spare battery (AT&T model 103, part number
89-0429-00-00, purchased separately) in the telephone base. The spare battery
compartment is located on the side of the telephone base. The spare charged
battery allows you to quickly replace a low handset battery, or in the event of
a power failure, make and receive short calls for up to three hours, depending
on the amount of use.
To install and charge a spare battery:
Compartment latch
Use only supplied rechargeable battery
or replacement battery (AT&T model 103,
part number 89-0429-00-00, purchased
separately).
1. Locate the spare battery
compartment latch on the side
of the telephone base, then
slide the latch to the right.
2. Once the battery compartment
pops out, place the
spare battery inside the
compartment according
to the diagram inside the
compartment.
3. Push the compartment with
battery in it back into the
telephone base, until it clicks
into place.
When you have finished installing the spare battery, the battery charging icon
will appear in the top right corner of the telephone base display. It takes at least
24 hours for the spare battery to reach a full charge. Once the spare battery is
fully charged, you can keep it charged until needed.
CAUTION:
To Reduce Risk
of Fire, Use Only
Supplied Battery
or Battery 103
BATTERY PACK
80-5808-00-00
CAUTION:
To Reduce Risk
of Fire, Use Only
Supplied Battery
or Battery 103
RECHARGEABLE
Ni-MH 3.6V 600mAh
WARNING:
DO NOT BURN OR
PUNCTURE BATTERIES
MADE IN CHINA
RECHARGEABLE
Ni-MH 3.6V 600mAh
WARNING:
DO NOT BURN OR
PUNCTURE BATTERIES
MADE IN CHINA