AT&T EP5632/EP5632-2 - Manual (Page 40)

36
System setup
Ringer Volume
You can choose from six handset ringer melody
volume levels. The ringer can also be turned off so
the phone does not ring during incoming calls.
To adjust the handset ringer volume:
1. Press MENU/
SELECT
in idle mode to enter the
main menu.
2. Press the UP and DOWN Navkeys to select
Ringers, then press
MENU
/SELECT to enter the
Ringers menu.
3. Press the UP and DOWN NavKeys to highlight:
• Ringer for HOME - set the ringer volume
and melody for the
HOME line.
• Ringer for CELL 1 - set the ringer volume
and melody for the first connected cellular
phone in the
Active Devices list (page
27).
• Ringer for CELL 2 - set the ringer volume
and melody for the second connected
cellular phone in the
Active Devices list
(page 27).
4. Press
MENU
/SELECT.
5. Press
MENU
/SELECT again to adjust the volume
setting.
6. To increase and decrease the handset ringer
volume:
• Press the UP and DOWN NavKeys, or
• Press the LEFT and RIGHT NavKeys, or
• Press the UP and DOWN volume controls on
the side of the handset
-OR-
To turn off the handset ringer:
• Press the
OFF softkey, or
• Press the DOWN NavKey, LEFT NavKey, or
DOWN volume control on the side of handset
until Ringer Off is shown on the display.
7. Press the SET softkey or
MENU
/SELECT to save
the setting.
Ringer for CELL 1
Ringer for CELL 2
Record New Ringer
Ringer for HOME
Ringers
Ringer Volume
SET OFF
Ringer Volume
SET OFF
Ringer Off
NOTE: Even if the
ringer volume is off, the
telephone base or handset
will ring at the lowest
volume setting during an
incoming intercom call.