AT&T EP5632/EP5632-2 - Manual (Page 51)

47
System setup
Ringer Volume
You can choose from six ringer volume levels on
the telephone base. The ringer can also be turned
off so the telephone base will not ring during
incoming calls.
To adjust the telephone base ringer volume:
1. Press the MENU softkey in idle mode to enter
the main menu.
2. Press the UP and DOWN NavKeys to select
Ringers, then press SELECT softkey to enter the
Ringers menu.
3. Press the UP and DOWN NavKeys to highlight:
• Ringer for HOME - set the ringer volume and
melody for the
HOME line.
• Ringer for CELL 1 - set the ringer volume
and melody for the first connected cellular
phone in the
Active Devices list (page 27).
• Ringer for CELL 2 - set the ringer volume and
melody for the second connected cellular
phone in the
Active Devices list (page 27).
4. Press the SELECT softkey.
5. Press the SELECT softkey again to select Ringer
Volume.
6. To increase or decrease the ringer volume:
• Press the UP and DOWN or LEFT and RIGHT
NavKeys.
-OR-
• Press the UP and DOWN volume controls
on the telephone base.
To turn off the telephone base ringer:
• Press the DOWN or LEFT NavKeys or the
DOWN volume control until the display
shows
Ringer Off. You can also press the OFF
softkey.
7. Press the SET softkey to save the setting.
Main Menu
Bluetooth
Settings
Ringers
Select
Ringers
Ringer for HOME
Ringer for CELL1
Ringer for CELL2
Select
SET
Ringer Volume
Ringer for HOME
Ringer Volume
Ringer Melody
Select
SET
Ringer Volume
OFF
OFF
Ringer Off
NOTE: Even if the
ringer volume is off, the
telephone base or handset
will ring at the lowest
volume setting during an
incoming intercom call.