AT&T EP5632/EP5632-2 - Manual (Page 25)

21
Bluetooth
Bluetooth at glance
The telephone base allows you to pair up to eight
Bluetooth devices. You can have a maximum of two
paired devices connected at anytime (two cellular
phones, or one cellular phone and one headset), but
, but
only one cellular phone or headset can be on a call
at a time.
Once you have paired a device with the telephone
base, the pairing information will be stored on the
Paired Devices list (page 25). To use a paired device,
it must be connected and on the
Active Devices list
(page 27).
When a device on the Active Devices list
becomes disconnected, the Auto Connect
function will automatically search for and re-
connect to that device. If the telephone base is
unable to connect to the device, the
Connect to
Device screen will appear on the display. Pressing
the
YES softkey allows the Auto Connect
function to continue searching for the device.
Pressing the
NO softkey ends the search, and the
device will remain disconnected.
To learn more about managing your Bluetooth
device(s), see the
Managing your Devices section
(page 25). To help you setup your Bluetooth
device(s), please follow the instructions in each
section and refer to the
Troubleshooting section
for help (page 92).
IMPORTANT INFORMATION
• Once you pair a device with the telephone base,
you do not have to repeat the pairing procedure
again, unless you delete the device from the
Paired Devices list (page 25).
• Press CANCEL on the telephone base at anytime
to return to a previous menu.
• When adding, removing, or replacing a Bluetooth
on the Active Devices list, all connected devices
will temporarily disconnect until the action is
complete. It may take up to two minutes to
reconnect.
NOTE: Before using
your Bluetooth device(s)
with the telephone base,
make sure that your
Bluetooth device(s) are not
connected to any other
device(s).
Connect to Device
Unable to connect.
Enable Auto Connect
Function?
YES No