Jenway 7315 Manual Italian - Manual (Page 22)

22
One press will lock the methods instantly. To unlock the methods press the key adjacent to the method
lock icon again. The methods are now unlocked. If the settings lock is active this must be disabled before
the method lock can be activated or deactivated.
In all the measurement modes if a user tries to save changes to a method when the method lock is active
the
padlock icon flashes on the screen and changes cannot be saved.
4.5 MoDe SeLeCtion
The mode selection function enables access to the various
measurement modes to be restricted. The required modes
can be selected and the settings lock activated to prevent
other users from accessing the deactivated modes. The
mode selection function can be accessed through the
instrument settings menu by pressing the key adjacent
to the
mode selection icon.
The measurement mode icons which are displayed on the
main menu are identified with a
mode shown icon. The
mode icons which are not displayed on the main menu
are identified with a
mode not shown icon.
To change a mode from displayed to restricted or vice
versa press the key adjacent to the
measurement mode
icon. Once the required modes have been selected press
the key adjacent to the
tick icon to save the changes.
The selected measurement modes will be displayed on
the main menu.
4.6 DiAGnoStiCS
The diagnostic function allows simple checks to be
carried out on the instrument. The wavelength can
be changed, the lamp can be turned on and off and a
sensitivity reading can be performed.
To exit this function without performing any checks press
the
back key.
4.7 GLP SettinGS
In addition to the time and date settings this instrument also has a user ID function. This function
enables an individual three digit ID number to be set. This will be displayed on all printouts and saved
results.
7315
09:02
0.00
500.0
nm
READ ON
Go to WL