Jenway 7315 Manual Italian User Manual
Page 57
57
Repeat presses will cycle between 0, 1, 2, 5, 10 or 50. Once the required options have been selected
press the key adjacent to the
tick icon to save and exit print-set up.
10.7.1.3 Print Setup – QUAntitAtion
In the quantitation measurement mode print setup menu
it is possible to print off the statistics for the standard
curve. To select the curve statistics press the key adjacent
to the
curve statistics icon. Repeat presses of the key
will cycle between a
tick and a cross icon for selected or
deselected.
Once the required options have been selected press the
key adjacent to the
tick icon to save and exit print-set up.
10.7.1.4 Print Setup – KinetiCS
In the kinetics measurement mode print setup menu it is
possible to print off the
statistics for the whole kinetics
experiment and the absorbance or % transmittance
values recorded at certain
data intervals. If the data
interval is set to 10 every 10th data point recorded is
reported. If no data is required the data interval can be
set to zero. To select the statistics to be printed press the
key adjacent to the
S
icon.
Repeat presses of the key will cycle between a
tick and a cross icon for selected or deselected. To select
the data interval press the key adjacent to the
data interval icon. Repeat presses will cycle between 0,
1, 5, 10, 30 or 60 seconds.
Once the required options have been selected press the key adjacent to the
tick icon to save and exit
print-set up.
10.7.2
Printing Results
Results displayed in the expanded operating menu can be
printed by pressing the key adjacent to the
printer icon.
Any options selected in the print setup menu will also be
reported when the
printer icon is pressed. Depending on
the printout destination selected the result will be sent to
the internal printer or to the external serial printer. If the
printer icon is pressed when there is not a result on the
screen the
no result to printer or no result to RS232
icon (depending on results destination) will flash up on
the screen.
Saved results can be printed by pressing the key below
the
printer icon. The printout will include the date
and time the result was generated, the user ID and the
measurement parameters.
English
English
1
81.7
0.088
400
09:02
%T
ABS
nm
Operating mode
Operator Id
Method Id
Wavelength
Sample interval
Sample Count
Results Destination
Cal Time/Date
ID
001
Photometrics
2
0
420
1
0
Internal
10 : 54 : 33 05/07/2010
TimeDateCell
01. 4.0. 091 10 : 54 : 40 05/07/2010