Jenway 7315 Manual Italian - Manual (Page 59)

The number of repetitions and time interval will be
displayed below the
autolog icon. To commence
autologging press the key below the measure sample
icon. Once the first measurement has been performed
the time period starts counting down until it reaches zero
and then the next measurement will be taken. This will
reduce the repetition number by one. When the number
of repetitions reaches zero autologging is complete.
Autologging can be stopped before all the measurements have been completed by pressing the key
adjacent to the
autolog icon. Confirmation will be needed to stop autologging. Press the key adjacent
to the tick icon to confirm stopping autologging or press the key adjacent to the cross icon to continue
autologging. If autologging is stopped before completion the measurements already recorded will be
saved under the previously entered batch name.
Once a set of results has been autologged to the USB
memory stick when the measure sample key is pressed
again the batch append/delete screen is displayed.
Pressing the key adjacent to the
batch append icon
enables the next set of results to be added to the existing
batch of results. Pressing the key adjacent to the
batch
delete icon will delete the first set of results and replace
them with the results that are going to be recorded. Press
the key adjacent to the
tick icon to confirm selection.
Press the key adjacent to the cross icon to cancel and
return to the expanded operating menu.
10.8.2 Selecting Result’s Destination
The autolog menu enables the result’s destination to be
set. To select the internal printer press the key adjacent
to the
printer icon. This option is only available if an
internal printer is connected. To select the USB memory
stick as the result’s destination press the key adjacent
to the
USB memory stick icon. This option is only
available if a valid USB memory stick is connected to the
instrument. To send the results to an external instrument
such as a PC or a serial printer press the key adjacent to
the
computer icon.
10.9 ConneCtinG to A PC
Connect the interface cable to the RS232 serial port on the rear of the instrument and connect to the
serial port on the rear of the PC. Turn the PC on and load the PC software by inserting the PC software
disc into the CD drive. If the PC software does not auto run open My Computer and double click on
the Jenway 73 series software icon. Follow the instructions to install the PC software to the required
location. Refer to the PC software manual for further instructions. Once the software is installed, turn
the mains power on to the instrument.
The PC software is pre-configured to run using the following settings:
9600 baud
8 data bits
no parity
1 stop bit
59
0.000
100.0
400
09:02
0002x
003s
ABS
%T
nm
JW0000-5
JW0000-5
0005 010s X