Jenway 7315 Manual Italian - Manual (Page 51)

51
SeCtion 10 – Saving, Printing and Autologging
The utility toolbar in the expanded operating menu provides access to printing, print setup options,
opening, saving and deleting results and methods and autologging options.
If the method lock has been activated the method selection menu is disabled.
Fig 10.1 - Expanded Operating Menu
10.1 SAVinG MetHoDS
Up to 48 methods can be saved in each of the measurement modes to the internal memory of the
instrument. Once the method has been saved to the internal memory the method can be saved directly
to a USB memory stick and opened on another instrument.
10.1.1 SAVinG MetHoDS to inteRnAL MeMoRY
In the expanded operating menu press the key adjacent
to the
method icon to open the method selection menu.
Select the location to save the method by pressing the key
adjacent to the location. Use the keys below the
arrow
icons to move page up or down. Press the key below the
create method icon to open the method naming menu.
The default method name will be displayed. To save the
method under the default name press the key adjacent
to the
tick icon. To change the name of the method press
the key below the eraser icon. One press of the key will
delete one letter, holding the key for 2 seconds will delete
the name completely.
To select letters use the keys adjacent to the arrow icons to move around the menu. Once the required
letter is highlighted press the key below the pencil icon to select the letter. Up to eight characters can
be selected. To change the letter case or to use numbers in the method name press the key below the
AB icon. Repeat pressing of this key will cycle between upper case, lower case and numbers. Once the
required name for the method has been entered press the key adjacent to the
tick icon to save the
method and return to the method selection menu.
If there is already a method saved in the chosen location
confirmation will be needed to replace the existing
method with the new one; press the key adjacent to the
tick icon to confirm replacement. Press the key adjacent
to the
cross icon to cancel and return to the method
naming menu. To exit the method naming menu without
saving the method press the
back key.
0.000
0.000
400
09:02
ppm
ABS
nm
01
02
03
04
TEST 05
06
07
08
TEST
A B C D E F G H I
J K L M N O P Q R
S
T U V W X Y Z _
01: TEST
01: EXP_1 ?
Print/print settings
Results selection menu
Method selection menu
Autolog menu