Jenway 7315 Manual Italian - Manual (Page 82)

Spectrum Single less than icon - decrease the wavelength by 1 times scan interval
Spectrum Double greater than icon - increase the wavelength by 10 times scan
interval
Spectrum Single greater than icon - increase the wavelength by 1 times scan
interval
Spectrum Wavelength icon - manually enter the wavelength
Spectrum Add points to the spectral points analysis table
Spectrum View spectral points analysis table
Spectrum Data point interval – used in print setup
Quantitation Measure sample
Quantitation Quantitation table – Opens quantitation table
Quantitation Number of standards
Quantitation View standard curve
Quantitation Curve fit – enables the curve fit to be adjusted
Quantitation Sigma icon – Displays curve statistics
Quantitation Create new standard curve
Quantitation Tick icon - Read Standard
Quantitation Back icon – Re-measure previous standard
Quantitation Cross icon – Cancel creation of new standard curve
Quantitation Curve statistics – used in print setup
Kinetics Settings menu
Kinetics Hand icon – Manual y-axis scaling
Kinetics Hand icon with cross through it - Auto y-axis scaling
Kinetics
0000s
Start time pause – Opens lag time/start on level menu
Kinetics 000 000 - Resets lag time, standard or factor values to zero
Kinetics Clock icon - Set the lag time
Kinetics ABS/%T icon - Set the start on level
Kinetics Greater than - Start above
Kinetics Less than - Start below
Kinetics No start on level set
82