Jenway 73 Series PC software - Manual (Page 24)

24
wavelength. However a warning will be displayed to warn that critical settings are being changed after
the zero calibration has been performed.
To continue click Yes, to cancel click No or Cancel.
If the wavelength is changed then the zero calibration must be performed again at the new
wavelength, before a sample can be measured. Alternatively a new concentration tab can be opened
and the required settings can be entered.
The calibration status will show the
zero calibration has been performed
and the unit is ready to measure the
sample.
Insert the cuvette containing the
sample into the sample chamber and
close the instrument lid.
Click on the Read button; the
instrument performs the
measurement and result is displayed
on the screen.