Jenway 73 Series PC software - Manual (Page 29)

29
5.1 Settings
To set the measurement parameters click on the Settings button.
This screen allows the sample
name, start and end wavelengths,
scan interval, resolution, and
operating mode to be set. If Auto
Logging is required the
parameters can be set in this
screen. Comments can be
entered which will be included on
the result printouts.
Once the required measurement
parameters have been entered
click on the OK button to accept
and continue with calibration and
sample measurement. To exit the settings without saving any measurement parameters click on the
Cancel button. To save the measurement parameters for future use click on the Save button. To load
previously saved measurement parameters click the Open button. For more details on saving and
opening method parameters refer to section 8.