Jenway 73 Series PC software - Manual (Page 27)

27
Insert the cuvette containing
the sample into the sample
chamber and close the
instrument lid.
Click on the Read button; the
instrument performs the
measurement and result is
displayed on the screen.
If the same sample needs to be measured more than once click on the Auto Log button. The
instrument will perform the required number of readings with the specified time interval between each
measurement. The results will be displayed on the screen. The batch name entered in the settings
screen will have 01, 02 etc after the name, to signify the order in which the results were generated.
auto logging can be stopped before all the measurements have been completed by clicking on the
Stop button. To recommence auto logging click on the Auto Log button again.
If the settings menu is re-entered following the sample measurement it is not possible to change the
wavelength. Alternatively a new concentration tab can be opened and the required settings can be
entered.