Jenway 73 Series PC software - Manual (Page 44)

44
6.1.6 Selecting number of standards
The number of standards used to
create a standard curve can be
changed from 2 to 6 standards.
To select the required number of
standards used click on the arrow
box on the drop down box and
select either 2, 3, 4, 5 and 6. If
there is only one standard
available the concentration
measurement mode should be
used.
6.1.7 Selecting the curve fit
The curve fit algorithm is
selectable between linear, linear
through zero, quadratic, quadratic
through zero and interpolate.
Click on the arrow on the drop
down box to select the best curve
fit for the standards.
To view the curve fit click on
Show Curve. The curve fit can
also be adjusted in this screen.