Jenway 73 Series PC software - Manual (Page 42)

42
6.1.2 Setting the wavelength
To select the wavelength
that the zero calibration and
sample measurements will
be performed at type the
wavelength into the text
box. The wavelength
selected should be the
same wavelength that the
standards were or will be
measured at. If a value
entered is outside of the
range of the instrument an
error icon will be displayed
and this must be corrected
before the settings screen
can be exited. Only numeric
values can be entered.
6.1.3 Selecting concentration units
The units of concentration can be
selected from a number of
options: no units, %, ppm, EBC,
SRM, mEq/l, mEq, M, mM, µM,
nM, U, U/l, U/ml, g/l, mg/l, µg/l,
ng/l, g/dl, mg/dl, µg/dl, mg/ml,
µg/ml, ng/ml, µg/µl, ng/µl, mol/l,
mmol/l. Click on the arrow on the
drop down box to select the units
required.